6 1/4" Buff and Shine Black Finishing Pad
The Buff & Shine Finishing Pad offers light cut and excellent finishing and should be used with a finishing polish.
Buff and Shine's quality and craftsmanship is second to none. They start by providing a consistent trim to the Velcro loop from the outer edge of the pad to prevent contact with the paint. Next all of their pads are consistently cut with the side walls of the pad perfectly straight on every pad. Take a look at your current stock of other brands and you will find inconsistent concave sidewalls. This is due to lower quality cutting procedures which B&S does not allow. With many brands Velcro peel off is often an issue but Buff and Shine uses an adhesive that will never come off...ever. It's heat resistant, chemical resistant and 100% fully washable over and over again. When you purchase Buff and Shine products, they stand behind their products with a 100% guarantee.
Features:
- Durability.
- Full Surface Contact.
- Superior Velcro Adhesive.
- Velcro backing offset.
- High Quality Craftsmanship.
- Best suited for Rotary and/or DA polishers with a 6" backing plate.
Primary Function:
- Finishing
Specifications:
- Material: Reticulated Polyester Foam
- Polishing Face Diameter: 6 1/4"
- Velcro Diameter: 5 7/8"
- Thickness: 1"
- Pores Per Inch: 80
- Color: Black
- Velcro Color: White
- Made in the USA
Polishing Directions:
- Fasten pad to machine taking care to securely center it on your backing plate
- Follow polish dependant tips regarding speed, pressure, amount of polish, and priming a clean pad with some products
- When polishing clean your pad after each section with your Foam Pad Brush before applying a couple more drops of polish for the next section.
Wax or Sealant Directions:
- Fasten pad to machine taking care to securely center it on your backing plate.
- Apply a few drops of wax or sealant to a clean dry finishing pad. For paste waxes simply twist the pad across the paste one or two turns to apply some wax to pad.
- Turn D/A on 1-3 or rotary on 600 rpm and spread across the surface. No pressure is needed with most waxes or sealants.
- Continue across panels until more product is needed.
Aftercare:
- Mix APC, or Dawn Detergent in a bucket of water.
- Allow the pad to soak at least 15 minutes or until vehicle is complete.
- When you are ready to clean, squeeze the solution into the pads and back out a couple times before thoroughly rinsing the pad with clean water. I like to use the pressure of a hose or under a tap for the rinsing stage.
- Place pads on sides with ventilation between or face down on a clean surface. I recommend a device similar to that which dishes dry on.
